Sorry your browser is not supported!

Sorry if this seems like a rather ridiculous question, but I just bought Model Pack 3, and I'm trying to add a roof to my warehouse. However, there seem to only be slanted roof edges.

Is there some way in the pack to make a flat roof to fill in the large center, and I'm just being stupid, or do I need to make one myself? I tried using a ceiling segment, but the roofs don't line up with the next layer.

I tried to stack slanted tiles to fill in the middle, but again, they don't align from layer to layer.

I know that I can fill the space by making kind of a 'wave' pattern with the slants just alternating angle back and forth, but that looks kind of odd.

Thank you all very much. Details are appreciated.

I'm sorry if I'm missing something basic. I might be because I searched the forums ahead of time, so I might be the only one who didn't figure it out...

umm if i were you, i would create a flat tile yourself and just add the texture from the roof segment to it. I think that would be the only way to get the flat roof segment you are after.

In order to do the roof, you need to have a 4x4 room.

Place the roof segments on each corner and then put the corners on the edge of the roof.